Page 45 - DCAP101_BASIC_COMPUTER_SKILLS
P. 45

Basic Computer Skills



                        Notes
                                                            Figure 3.2: Read-Only Memory (ROM)















                                       3.2.3 Programmable Read-Only Memory (PROM)
                                       There are two types of read-only memory (ROM) - manufacturer-programmed and user-
                                       programmed. A  manufacturer –programmed ROM  is one in which data is burnt in by the
                                       manufacturer of the electronic equipment in which it is used. For example, a personal
                                       computer manufacturer may store the system boot program permanently in a ROM chip
                                       located on the motherboard of each PC manufactured by it. Similarly, a printer manufacturer
                                       may store the printer controller software in a ROM chip located on the circuit board of each
                                       manufactured by it. Manufacturer-programmed ROMs are used mainly in those cases where
                                       the demand for such programmed ROMs is large. Note that manufacturer-programmed ROM
                                       chips are supplied by the manufacturers of electronic equipment and it is not possible for
                                       a user to modify the programs or data stored in a ROM chip. On the other hand, a  user-
                                       programmed ROM  is one in which a user can load and store “read-only” programs and data.
                                       That is, it is possible for a user to “customize” a system by converting his/her programs
                                       to micro-programs and storing them in a user-programmed ROM chip. Such a ROM is
                                       commonly known as  Programmable Read-Only Memory (EPROM) because a user can program
                                       it. Once the user programs are stored in a PROM chip they can be executed usually in a
                                       fraction of the time previously required. PROMs are programmed to record information
                                       using a special device known as PROM-programmer. However, once the chip has been
                                       programmed, the PROM become a ROM. That is, the information recorded in it can only be
                                       read (it cannot be changed). PROM is also non-volatile storage, i.e., the stored information
                                       remains intact even if power is switched off or interrupted.


                                                     Figure 3.3: Programmable Read-Only Memory (PROM)


















                                       3.2.4 Erasable Programmable Only Memory (EPROM)
                                       Once information is stored in a ROM or PROM chip it cannot be altered. Erasable
                                       Programmable Read-Only Memory (EPROM) overcomes this problem. As the name implies,





             38                                LOVELY PROFESSIONAL UNIVERSITY
   40   41   42   43   44   45   46   47   48   49   50